DroopyBassets75 mentioned: Many thanks for the recommendations on These bullets. The only rationale why I am using these is usually that I currently had them loaded up for an AR plus a Mini-fourteen and even now Have got a thousand or so unfastened 55 grain Hornady FMJ bullets to work with.

The decapping pin inside the sizing die may not be stout plenty of to knock these out without being weakened, so deprime them prior to resizing using a Distinctive die expressly created for this job.

• We'd like to bear in mind the variances in loading pistol and rifle. That is to convey, what issues is The proportion of variation, not the number of grains of variation.

Due to the fact a great deal of shooters think Vit is off the deep-finish expensive, it would be The one thing You should buy now.

2) Most significantly, H335 is compared with most all other powders in that it receives very terrible when loaded over and above shown data in your bullet.

Must I give absent the facility to the buddy That may get some good use away from it, or maintain on to it in the event I get A different gun Which may do very well with it?

And most of all through these moments, it's always accessible when almost everything else is out of stock.

Which is also my varmint load since it provides me sub MOA at in excess of 3kfps.  I am going to go have a look at my notes and update if that helps.

It shoots good but is soiled and as mentioned receives hot in the summertime. For me I like Tac and AR COMP far better. As of lately I switched to Varget for .308/.223.

Posts: 455 among H335 and CFE 223 ? I've utilised both equally, in both of those situations accuracy variances have been negligible. Small enough in charge to the dude at the rear of the trigger. I like H335 though, predominantly due to the fact I operate it in a number of platforms.   Kimber84

Posts: 466 I was instructed within the gun store that the 41 primers are merely a thicker cup, for use with AR form rifles. AR-15's typically have a absolutely free floating firing pin, meaning it taps the primer when loading.

Posts: three,881 I contain the data in my reloading guide, I had been just inquiring if any person experienced in comparison both of those powders. more info Like I stated I are not able to manage to get H335 to shoot as accurate and CFE223.   rebs

But lots of handloaders usually continue to keep employing what is actually labored for them for many years, either given that they by no means check out the rest or they purchased plenty of it.

I was underneath the impression that H335 is effectively W748? Not so? Unquestionably works the same as it in my 223AI.